HVAC Work by C.S.W. Power Solutions

Air Handlers, Ductwork and Condensing Units in San Antonio

HVAC work by C.S.W. Power Solutions in San Antonio: air handlers, plenum and duct connections, outdoor condensing units and system service.

This section of the portfolio shows heating and cooling work performed by C.S.W. Power Solutions under Texas HVAC licence TACLA26479R. It is a short, honest selection rather than a padded archive: indoor air handlers with insulated plenums and flex duct take-offs connected, attic-mounted air handlers with insulated duct runs routed to the plenum, outdoor condensing units set on exterior pads with the electrical disconnect mounted on the wall beside them, and one service frame with a manifold gauge set connected at a condensing unit. That service frame is labelled work in progress, because a gauge set on a unit is diagnosis, not a completed installation, and presenting it otherwise would misrepresent the job. Captions name the equipment visible in the frame and nothing more. No address, customer, date or system tonnage is attached to any photograph, and no claim is made about efficiency gains or equipment lifespan on the strength of a photograph. In San Antonio the practical questions on a changeout are usually whether the existing ductwork and electrical supply suit the new equipment, whether the condensate drain is routed properly, and whether the permit and inspection are handled; those are worth asking any contractor before signing anything. Because C.S.W. self-performs HVAC alongside electrical, plumbing and general contracting, the electrical circuit and disconnect an outdoor unit needs are not a separate trade contract, and neither is the drywall repair after an attic air handler is replaced. Call 210-468-8279 or email karen@cswpsolutions.com for a written, itemized estimate. Veteran-owned and operated, VA Builder Registration #09311.